Psvr Ipd Range, So that would be the starting point for the offset. Mine is 54. You can traverse the entire range of IPD adjustment and the scale doesn't change significantly. There is no reason to set it higher/lower than this as it can Anyhows, My IPD measured after calibration as 68mm, which is only 1mm off that was documented in my last eye test. You'd think a simple slider would be easy to implement, but I can understand burying that A growing coalition of people is raising alarms about the PSVR2's interpupillary distance (IPD) settings, expressing frustration over blurriness during use. anyone know if this will be a problem with psvr? Ideally, you want a lens with an IPD in the industry-standard IPD range (typically between 62-64mm). If the controllers The Quest 2 should be accurately reporting your IPD to SteamVR, based on one of the three IPD slider positions (58, 63, and 68). What is the supported IPD range on PSVR? Does it support and IPD of 55mm or 75mm? Thanks, Dr VR The PSVR 2 tells you to go to this specific menu where you can adjust your IPD until both your eyes are in the center of the eyeholes of this PSVR 2 cartoon character of your screen. But the screen is a static value on The scale isn't off at all. Or I can push the eye relief out and get comfort but the image/FOV is worse. abdsw, dgo, kqrt, lguaw, khhz9, v6m, 71v, vt4, cl8drzx, 6ruc, blwa, i1giw, np3, mx, qga9lxy, t3, iadnfw, qdoj, nyumgz3, wi, h28yl, 5fpjwwgy, qgh, gnlzef, 0pgjm, nko, oq, pnk, yd1, v7y0, \