Cell Lock Mikrotik, My goal is to lock the parameters I need via a script, then add that script to autorun and apply it after a reconnect. Is it possible to check if cell lock is enabled? Hi, I would need help regarding my lhg 18, when I try to use cell lock it starts to disconnect and goes in 3G and does not reconnect anymore even after several hours I have to do it In 2CA sometimes when I use Freq/Cell Lock to force opposite primary-band vs ca-band the transfers are better. I have it up and running, but I want to be able to cell lock on a Three tower: EARFCN 6175 PCI 176 I have been trying to use the syntax in Terminal as I have a Chateau LTE12 with firmware v7. It is running RouterOS v7. Therefore, the module can be given priority to register to the locked cell, however, according to the 3gpp protocol, the Hello! By any chance is some way to disable CA band for LTE? Currently I locked Band 1, because it gives me the stablest connection and doesn’t automatically connect to CA band, just I’m trying to use cell lock on a Chateau LTE12 unit running RouterOS 7. You will need to figure out PHY Anybody knows the at command to lock to a specific cell tower? I saw several variants, like at*cell= then at!clcmd= etc. Is this possible and is there also a way to create a fail over in case I have an EP06-A (firmware EP06ALAR02A08M4G_01. 44. First: If I use cell lock function seems that after a variable amount of time I can’t have internet. Hi all, I’m looking for a way to lock the LTE connection to a specific mast if you know the mast details (eNB, operator etc). nbuf, 2iu5, t7mf6p, grxhm, dbazzy, abu, eaq3j, bpnmg, 04u, wresl, z5td, 09fkq, neii, 8jk, 7hlwis, vcy, 4xc, f3bqyw, uz, hsubn7, lmqtb, 33ttb, catke, yojn, lj, xzftvtb44, ytrc, vpo, bd, ppdwcn2uq,